diff --git a/draft-ietf-lsvr-l3dl.xml b/draft-ietf-lsvr-l3dl.xml
index 80dab21..7356b47 100644
--- a/draft-ietf-lsvr-l3dl.xml
+++ b/draft-ietf-lsvr-l3dl.xml
@@ -1101,7 +1101,9 @@ q-->
     <section anchor="mplslist" title="MPLS Label List">
 
       <t>As an MPLS enabled interface may have a label stack, see <xref
-      target="RFC3032"/>, a variable length list of labels is needed.</t>
+      target="RFC3032"/>, a variable length list of labels is needed.
+      These are the labels the sender will accept for the prefix to
+      which the list is attached.</t>
 
 <!--
     protocol "Label Count:8,Label:20,Exp:3,S:1,Label:20,Exp:3,S:1,more ...:8"
@@ -1129,7 +1131,8 @@ q-->
       <t>The MPLS IPv4 Encapsulation describes a logical link's ability
       to exchange labeled IPv4 packets on one or more subnets.  It does
       so by stating the interface's addresses the corresponding prefix
-      lengths, and the corresponding labels.</t>
+      lengths, and the corresponding labels which will be accepted fpr
+      each address.</t>
     
 <!--
     protocol "PDU Type = 6:8,Payload Length:32,Count:24,Serial Number:32,Encaps Flags:8,MPLS Label List ...:16,IPv4 Address:32,PrefixLen:8,more ...:8,Sig Type:8,Signature Length:16,Signature:32"
@@ -1166,7 +1169,8 @@ q-->
       <t>The MPLS IPv4 Encapsulation describes a logical link's ability
       to exchange labeled IPv4 packets on one or more subnets.  It does
       so by stating the interface's addresses, the corresponding prefix
-      lengths, and the corresponding labels.</t>
+      lengths, and the corresponding labels which will be accepted fpr
+      each address.</t>
 <!--
     protocol "PDU Type = 7:8,Payload Length:32,Count:24,Serial Number:32,Encaps Flags:8,MPLS Label List ...:16,IPv6 Address:128,Prefix Len:8,more ...:8,Sig Type:8,Signature Length:16,Signature ...:32"
 -->
@@ -1204,7 +1208,8 @@ q-->
       <t>The MPLS IPv6 Encapsulation describes a logical link's ability
       to exchange labeled IPv6 packets on one or more subnets.  It does
       so by stating the interface's addresses, the corresponding prefix
-      lengths, and the corresponding labels.</t>
+      lengths, and the corresponding labels which will be accepted fpr
+      each address.</t>
       
       </section>
     </section>